10BDL4551T How to turn off and on touch

10BDL4551T How to turn off and on touch


Turn Off touch


To turn off touch, you need to send SICP Over IP command to the screen

Command
SICP Command (HEX)
Turn Touch Off
06 01 00 1E 00 18
Turn Touch On
06 01 00 1E 01 19

Turn On Touch

To turn on touch, you can send SICP Over IP command above to the screen or Press the following sequence on the screen
Menu, Menu, Volume+, Volume-, Volume-, Volume+

Turn Off Touch using an app


Download and install apk from this link


    • Related Articles

    • Philips BDL Remote Control Not Working

      Philips Signage Remote control not working: [1] Are you using the correct remote control (RC)? Part number: 398GRABDDNEPHT, see picture below: See important note at the end of this document [2] The green led must blink when you press the OK button on ...

    • 10BDL3051T - Hotkeys - How to get int to Admin Mode, Quick Info, Enable touch, Turn on Screen, etc

      Table of Hotkeys Note:- 1. Disabling touch function is only valid through SICP command. 2. Turning off the screen is only valid by - SICP command or - Settings -> Display -> Sleep or - Settings -> Signage Display -> Schedule -> End Time 3. Turning on ...

    • 24BDL4151T - Hotkeys - How to get int to Admin Mode, Quick Info, Enable touch, Turn on Screen, etc

      Table of Hotkeys Note:- 1. Disabling touch function is only valid through SICP command. 2. Turning off the screen is only valid by - SICP command or - Settings -> Display -> Sleep or - Settings -> Signage Display -> Schedule -> End Time 3. Turning on ...

    • BDL4252E - ghost touch issue

      When ghost touch (unsolicited touch) are detected on the screen, this can be caused by external device feeding the screen with mouse coordinate somehow. A case was reported by a customer once where a screen exhibited a ghost touch issue. At the end, ...

    • BDL - xxBDL4050D (Dragon 1.0) - Setting up for RS232

      RS232 via DB9 cable Set: Home->Config1->RS232-Routing->RS232 Check the Home->Configuration 2->monitor ID is set to the value that will respond to your SICP command RS232 via Network Set: Home->Config1->RS232-Routing->(LAN->RS232) Set Home->Advanced ...