BDL3117P - Common Configuration

BDL3117P - Common Configuration


Menu (press the HOME button on the remote control)

Configuration 1 ⇾ Switch on State = Force on         // When power is restored to the screen, the screen automatically turns on
Configuration 1 ⇾ Boot on Source                             // This is where you set the screen's default video source after boot up
Option ⇾ Power save = Mode 4                                 // Mode 4 means the screen never turns off

Option ⇾ Date and Time ⇾ manually set the date/time      //Set the Date & Time
                        Daylight Saving is only observed in NSW, VIC, TAS, ACT, SA
                        To configure it
                        Daylight saving start date: 1st Sunday of Oct
                        Daylight saving stop date: 1st Sunday of Apr
                        Correction Time: 1.0
                        Daylight Saving Correction: On (Only for NSW, VIC, TAS, ACT, SA)

Option ⇾ Schedule
      Choose a Schedule
            Status               // On =  schedule is enabled
            Source              // Set the source of the schedule when it's activated
            On Time           // Time when schedule start
            Off Time           // Time when schedule finish
            Repeat Mode    // Select all days or as appropriate
            USB Playlist      // This is applicable only when source is USB 

    • Related Articles

    • Philips BDL Remote Control Not Working

      Philips Signage Remote control not working: [1] Are you using the correct remote control (RC)? Part number: 398GRABDDNEPHT, see picture below: See important note at the end of this document [2] The green led must blink when you press the OK button on ...

    • BDL3651T - Common Procedures

      How to perform a factory reset: This function allows you to clear all user data and settings. Only the data stored in the internal storage will be cleared and cannot be recovered, the data includes the device settings, installed APPs, APPs’ data, ...

    • Customer B - BDL4050D Fusion Signage Menu Board Common Issues

      Content Are Not Updating Ensure screen is connected to the Local Wifi - click here If the screen status is offline although it is connected to local wifi, there's a possibility that the customer's LAN doesn't connect to the internet. Please try ...

    • Customer B - BDL4550D Menu Board Common Troubleshooting Steps

      Wifi issues Step 1 - Turn the screen of at the powerpoint leave it off for 10-15 minutes and then turn it back on again before trying to connect it back to the wi-fi. Step 2 – If rebooting the screens doesn’t work try turning of the router/modem for ...

    • BDL - xxBDL3550Q - Setting up for RS232

      RS232 via DB9 cable Set: Home->Config1->RS232-Routing->RS232 Check the Home->Configuration 2->monitor ID is set to the value that will respond to your SICP command RS232 via Network Set: Home->Config1->RS232-Routing->(LAN->RS232) Set Home->Advanced ...