Muso Gen 2 - Reset Procedure
Ensure that the Mu-so 2nd Generation is switched on.
The Mu-so 2nd Generation cannot be in a standby mode to perform the reset.
Locate the Reset switch on the side of the Mu-so 2nd Generation.
Use the Pin Hole reset tool to press and hold the Reset switch (for at least 10 seconds) until the Network Indicator LED changes to Orange.
Your Mu-so 2nd Generation has been reset and will start again in standby mode. The reset process will take about 30 seconds.
Related Articles
Muso Gen 1 Deep Reset Procedure
The instructions for the deep reset are: 1. Power off the unit at the wall and give it 30 seconds for its power supply to fully discharge. 2. Press the reset pin into the reset hole (next to the LED status indicator) until you feel a slight click, ...
Mu-so Gen 2 — forced USB firmware update procedure
Overview This article is for Westan agents and authorised service agents. It covers the Mu-so Gen 2 forced USB firmware update procedure, including the complete file set required and the most common error (missing the forceupdate.naim file). When is ...
Mu-so Gen 2 — no audio via HDMI / eARC from TV
Overview The Mu-so Gen 2 supports HDMI ARC / eARC input for TV audio. When a customer reports no audio via HDMI from their TV, this is almost always a TV configuration issue rather than a fault with the Mu-so. This article covers the diagnosis and ...
Mu-so Gen 2 / QB 2 — not found on network or Spotify dropping out
Overview This is the most common network-related support issue for Mu-so Gen 2 and Mu-so QB 2. The symptoms — device not found in the Naim App, Spotify Connect dropping, or intermittent audio — are almost always caused by router or network ...
N50 and NDS333: isolated testing and setup
NB: your dealer should be able to give you help and advice on the best setup and guide you through the setup process. 1: Unplug the power cable from the NAIT 50 2: Unplug the power cable from the 555 3: Remove the inter-connects between the power ...