When we look over the front of the screen it is not uniform ?
When installing display you should stop and evaluate after each row to ensure alignment, there is lots of adjustment to be made by adjusting the 4 affixing bolts to each cabinet AND checking the interconnecting locks between cabinets have in fact been locked properly.
Also there can be occasions where the plastic mask unseats which will cause this affect but can be remedied by carefully re inserting into position.
Whilst some adjustment can be made post install, it is much easier to assess and align at the end of each row / column.
Related Articles
How to clean outdoor screen
Hose it off. Low pressure. These are only IP65 front so low-pressure water jets only. A soft brush may be used. Only run horizontally or vertically or they may dislodge led lamps. Do not press hard. Worst case isopropyl alcohol and a soft lint free ...
Half the screen has gone black ?
Sections of screen going black indicates either Loss of lead in power to that section (check circuit breakers and / or isolators) Loss of Lead in Data (Check Data connectivity to the lead in cabinet and the data connectivity from the LED processor ...
I cannot get the screen to power on ?
Check the circuit breakers and main breaker to ensure the venues power is in fact on and then check the rear of the cabinets to see if there are indicators lights on . Indicator lights on means there is power but no video signal and you need to – • ...
Aurora Front and Rear Service Aluminum LED Displays
How do I know if the screen is receiving data or not ?
To ascertain if screen cabinets are receiving data, check the green indicator light at the rear of the cabinet – • Slow blinking indicates power but no data signal • Rapid blinking indicates data and incoming signal