xxBDL505xP (Dragon 1.5) Setting up for RS232

xxBDL505xP (Dragon 1.5) Setting up for RS232


RS232 via DB9 cable

Set: Home->Config1->RS232-Routing->RS232
Check the Home->Configuration 2->monitor ID is set to the value that will respond to your SICP command

RS232 via Network
Set: Home->Config1->RS232-Routing->(LAN->RS232)
Set Home->Advanced option->Power Save= Mode 3 or Mode 4
Home 1888->Settings->Signage Display-> Network application->SICP network port
     - enable SICP Network port
     - ensure it is set to port 5000
Check the Home->Configuration 2->monitor ID is set to the value that will respond to your SICP command

    • Related Articles

    • BDL - xxBDL4050D (Dragon 1.0) - Setting up for RS232

      RS232 via DB9 cable Set: Home->Config1->RS232-Routing->RS232 Check the Home->Configuration 2->monitor ID is set to the value that will respond to your SICP command RS232 via Network Set: Home->Config1->RS232-Routing->(LAN->RS232) Set Home->Advanced ...

    • Dragon 1.0 - Setup Guide - Video Wall

      Note: This guide shows you the steps required to set-up a video wall Video wall daisy chaining (passing video signal from one screen to another) must only be done through DVI loop through and/or Display Port loop through. Using the 1st screen's HDMI ...

    • xxBDL4050D xxBDL4051T 65BDL3051T (Dragon 1.0) Wifi keep dropping off

      Ensure your xxBDL4050D's Android SW is up to date (see the latest version in the SOP Below) https://support.westan.com.au/portal/kb/articles/bdl-dragon-1-0-xxbdl4050d-android-module-software-update Android Version FB10.07 and lower did have this ...

    • xxBDL4051D (Dragon 1.6) - Installing APK and Playing Content From It

      Portrait Mounting This display can be installed in portrait position. 1. If the table stand is attached, remove it first. 2. Rotate the display counter-clockwise by 90°. The “ ” logo should be on the RIGHT side when facing the display. 3. Set the ...

    • xxBDL4051D (Dragon 1.6) - Playing content from USB Drive

      Portrait Mounting This display can be installed in portrait position. 1. If the table stand is attached, remove it first. 2. Rotate the display counter-clockwise by 90°. The “ ” logo should be on the RIGHT side when facing the display. 3. Set the ...