Introduction

The latest FB02.09T FW is a 2 steps operation.

1. NVM Reset (NVM.BIN) - to reorganize the BDL4052E Memory to suit FB02.09T (about 2 mins)

2. Forced update SW (upgrade_loader.pkg) - to update the BDL4052E SW (about 15 mins)

Each steps above require its own USB Drive, so 2 USB Drives are required

Performing Forced upgrade will wipe all the installed app and reset the settings.

At the end of the Forced upgrade process, the screen will show the Welcome screen again

NVM Reset (NVM.BIN)

NVM (Non Volatile Memory) Reset Procedure overwrite the NVM memory area with a model specific NVM image that is usually loaded during the Screen's assembly process.

The NVM image used is dictated by the LCD component (the front part of the Screen that lit up and produces picture) used in the Screen.

That's why different Philips BDL model WILL require different NVM files

Even 2 HFL BDL of the same model, with different serial number range may use different LCD types, and thus require different NVM files

Format the USB Drive with the following settings:

  File system=FAT32

  Allocation unit size = 64 kilobyte

Download NVM.BIN file (Model dependent) into USB Drive.

Choose the correct NVM.BIN file based on the Model

the model of the screen should be shown on a label behind the screen

if you can't access the back of the screen to see the label, please press info,7,7. The model will be shown on the screen

Model		Download Link
65BDL4052E		[Download]
75BDL4052E		[Download]
86BDL4052E		[Download]

Download and put files into the root directory of the USB Drive.

Check that the filename are precisely the following names:
NVM.BIN not NVM(1).bin or nvm.bin, etc

Performing NVM Reset

See the video in this link: https://photos.app.goo.gl/RYy2QDXdekEQ7uqr7

Insert the USB Drive to the USB port on the side of the screen

Power off the screen from the power plug (not using the remote)

Power on the screen from the power plug.

Software update will begin automatically

Wait about 15 minutes for the forced update process to finish.

If this is a virgin screen (never been configured before), once it finish, you'll be shown the Welcome screen.

Otherwise, it'll show the default start up screen 

Download the latest upgrade_loader.pkg (platform dependent) into USB Drive.

Turning off aging mode

To turn it off, please follow the following steps:

1. Set the source to HDMI

2. Go into Factory Menu by pressing Home,1,9,9,9,back on the remote

3. Navigate to the Burn-In Mode setting called Aging mode, and set it to off, and the colour cycling will disappear

 

Installing Correct Version of TeamViewer Host app

To be able to remotely control the screen via Teamviewer session, the original Teamviewer app that came with the screen need to be uninstalled, and the version TeamViewerHost_signed_4052E.apk need to be installed afterwards.

Please follow the SOP in this link https://support.westan.com.au/portal/en-gb/kb/articles/bdl4052e-teamviewer)