WP-20CT Video and audio doesn't get relayed to the receiver over HDBaseT

To configure the WP-20CT via its web interface

Connect a Computer via USB C to the WP-20CT

Set your  computer ip address to 192.168.1.2

Open up the browser and open up 192.168.1.39 to go to the portal

Check that the input and output ports are available

If necessary copy the EDID from the Input to the output ports.

• Related Articles

• Kramer Limited Warranty Statement

  Rev: 2025-04 The warranty obligations of Kramer Electronics Inc. (“Kramer Electronics”) for this product are limited to the terms set forth below: What is Covered This limited warranty covers defects in materials and workmanship in this product. What ...

• Kramer KAC-SCD-10 / AudioCodes RX-Panel showing Thumbprint Verification - Thumbprint has failed verification

  Issue description: Panel just shows "Thumbprint Verification - Thumbprint has failed verification" Solution: This issue has been resolved with firmware version 2.8.950 Firmware file RXPANEL_AN_2.8.950.zip Firmware can be uploaded in the teams action ...

• Provision and Unprovision a Kramer Brain

  Please find the attached documentation on the procedure !