BDL4252E Useful Configuration Parameters
OSD Settings->Configuration->Boot On Source: this dictate which source the screen will use upon boot up.. Default is last source
Related Articles
Philips BDL Remote Control Not Working
Philips Signage Remote control not working: [1] Are you using the correct remote control (RC)? Part number: 398GRABDDNEPHT, see picture below: See important note at the end of this document [2] The green led must blink when you press the OK button on ...
BDL - xxBDL3550Q - Setting up for RS232
RS232 via DB9 cable Set: Home->Config1->RS232-Routing->RS232 Check the Home->Configuration 2->monitor ID is set to the value that will respond to your SICP command RS232 via Network Set: Home->Config1->RS232-Routing->(LAN->RS232) Set Home->Advanced ...
BDL - xxBDL4150D (Himalaya 2.0) - Setting up for RS232
RS232 via DB9 cable Set: Home->Config1->RS232-Routing->RS232 Check the Home->Configuration 2->monitor ID is set to the value that will respond to your SICP command RS232 via Network Set: Home->Config1->RS232-Routing->(LAN->RS232) Set Home->Advanced ...
BDL - xxBDL4050D (Dragon 1.0) - Setting up for RS232
RS232 via DB9 cable Set: Home->Config1->RS232-Routing->RS232 Check the Home->Configuration 2->monitor ID is set to the value that will respond to your SICP command RS232 via Network Set: Home->Config1->RS232-Routing->(LAN->RS232) Set Home->Advanced ...
Knowledge Base Article: XXBDL4550D Best Practice Configuration GuideX
This Knowledge Base (KB) article has been updated to include all configuration points in structured tables for better scannability, removing all specific customer details while retaining the ticket reference. KB Article: XXBDL4550D New Setup & Best ...