Mu-So2 Remote - How to Open Battery Compartment
Please watch this video
The main principle is to push the middle of the compartment, within the half circle to release the internal latch of the cover.
Some people will find it hard to open the battery compartment, due to dry hands/fingers.
Related Articles
Mu-so Gen 2 — forced USB firmware update procedure
Overview This article is for Westan agents and authorised service agents. It covers the Mu-so Gen 2 forced USB firmware update procedure, including the complete file set required and the most common error (missing the forceupdate.naim file). When is ...
Mu-so Gen 2 — no audio via HDMI / eARC from TV
Overview The Mu-so Gen 2 supports HDMI ARC / eARC input for TV audio. When a customer reports no audio via HDMI from their TV, this is almost always a TV configuration issue rather than a fault with the Mu-so. This article covers the diagnosis and ...
Mu-so Gen 2 / QB 2 — not found on network or Spotify dropping out
Overview This is the most common network-related support issue for Mu-so Gen 2 and Mu-so QB 2. The symptoms — device not found in the Naim App, Spotify Connect dropping, or intermittent audio — are almost always caused by router or network ...
Muso Gen 2 - Reset Procedure
Ensure that the Mu-so 2nd Generation is switched on. The Mu-so 2nd Generation cannot be in a standby mode to perform the reset. Locate the Reset switch on the side of the Mu-so 2nd Generation. Use the Pin Hole reset tool to press and hold the Reset ...
ND5 XS2 / NDX 2 — no audio from RCA output
Overview A common setup issue where the ND5 XS2 (or NDX 2) appears to be working correctly in the Naim App but produces no audio through the connected amplifier. This is almost always caused by the analogue RCA output not being enabled in the Naim ...