N50 and NDS333: isolated testing and setup
NB: your dealer should be able to give you help and advice on the best setup and guide you through the setup process.
1: Unplug
the power cable from the NAIT 50
2: Unplug
the power cable from the 555
3: Remove
the inter-connects between the power supply and NS 333
4: Ensure
the DIN cable is connected between the NS 333 and the NAIT 50 (Stream input)
and that it is secure.
5:
Connect a power cable into the NSS 333
6: On the
NAIT 50, ensure the Instant On / Standby switch is set to ‘On’
7:
Connect a power cable into the NAIT 50
8: Turn
on the NSS 333, allow it to boot up and join the network etc.
9: Play a
track from a known source (Tidal / Qobuz / Server / Net Radio)
10: Go
into the app and ensure that the output is selected (it will reset after a
factory reset) and choose ‘Din’.
10: Turn
the volume to ‘Zero’ on the NAIT 50.
11: Power
on the NAIT 50 using the ‘Mains’ button (the ‘power’ LED needs to be bright and
not dull)
12:
Select ‘Stream’ on the front of the NAIT 50
13: Then
turn up the volume on the NAIT 50.
Related Articles
Muso Gen 2 - Reset Procedure
Ensure that the Mu-so 2nd Generation is switched on. The Mu-so 2nd Generation cannot be in a standby mode to perform the reset. Locate the Reset switch on the side of the Mu-so 2nd Generation. Use the Pin Hole reset tool to press and hold the Reset ...Naim: How does the warranty process work?
The Claim Process Please submit a ticket through the Westan Support ticketing portal in order to have a warranty claim submitted and reviewed. A ticket must be lodged for all faults, failures and non-user related damages, whether you are looking for ...Naim Troubleshooting and FAQs
For knowledge base and troubleshooting guides you can refer to the FAQ pages for your Naim product via this links: https://www.naimaudio.com/assistanceNaim Limited Manufacturer's Warranty
Westan Australia Pty Ltd (40 111 699 819) (hereafter "Westan") acts as a distributor for the manufacturer of Naim products. Westan offers this warranty against defects for Naim products purchased within Australia under the following conditions. Our ...Muso Gen 1 Deep Reset Procedure
The instructions for the deep reset are: 1. Power off the unit at the wall and give it 30 seconds for its power supply to fully discharge. 2. Press the reset pin into the reset hole (next to the LED status indicator) until you feel a slight click, ...