INF 40 Series - VGA display output appear off centre

INF 40 Series - VGA display output appear off centre

Explanation


The unit tries to adjust automatically the first time its turned on during start up with VGA connected.
If the display is unable to determine the correct positioning it will place it at the factory default which may or may not be correct.
When the default position is incorrect customers can use the auto setting to try again and if that fails can then use the manual settings to adjust the position of the image themselves.

Auto Adju​st The Video Position on the Screen


On the display using the remote (the remote is the only way to get to these settings)
Press Menu
Use the right arrow to slide over to display
Select Auto



Check the Advance Display Setting of the PC and adjust if necessary


Check the advanced display settings on both PCs and verify that the GPU driver is set to the same refresh rate.




    • Related Articles

    • INF 40 Series - RepairGuide Mainboard Replacement

      When the panel starts in AT View mode after replacing the mainboard, loading the correct firmware from below will correct this. Firmware Download links INF6540 Firmware Download: [Download] Updated: May 18, 2022 INF7540 Firmware Download: [Download] ...

    • INF 40 Series - Re-image Android Firmware

      Firmware and Software Download links  INF6540 Firmware Download: [Download] Updated: May 18, 2022 INF7540 Firmware Download:  [Download] Updated: May 19, 2022 INF8640 Firmware Download: [Download] Updated: May 19, 2022 Lightcast File Viewer (Can be ...

    • INF 50 Series - User Manual

      Web PDF – See attachment below

    • InFocus INFxx00 Series - Documents

      Click on the corresponding file at the bottom of this page to download it. 00-Series Family Datasheet: InFocus_INFxx00_Series_Family_Datasheet.pdf Engineering drawings: 65": InFocus_INF6500_Engineering_Drawings.pdf ...

    • INF 40 Series - RS232 Commands

      InFocus JTouch 4.0 RS232 Commands INF6540e, INF7540e, INF8640e Result Set success reply：34 30 31 2B 0D Set  fail         reply：34 30 31 2D 0D RS232 Settings  Baud Rate: 9600bps  Data bit: 8bits  Parity: None  Stop bit: 1 Lan RS232 Settings   IP: Ip ...