When we turned on the display after installation, parts of the screen are in the wrong position ?

When we turned on the display after installation, parts of the screen are in the wrong position ?

This will indicate that the display cabinets have NOT been installed in the order as shipped from 
Aurora. Check the Aurora documentation to ascertain the correct layout and position. This can be resolved by loading up novastar software and re sending the display configuration to the screen.
FIRST, be sure to save the existing config files as a matter of redundancy. (refer to Aurora Quick Guide or contact Westan support if you arequire assistance)
Ensure you selected “send to HW” first and check that the display is now correct prior to saving screen configuration permanently in receiver card memory.

    • Related Articles

    • I have turned the screen on and I am seeing a white snow like image ?

      This issue indicates a lack of configuration file or incorrect configuration file. In this instance  please locate the configuration (Intelligent file) and reload it to the screen as supplied on the  USB or contact Westan Support.

    • Half the screen has gone black ?

      Sections of screen going black indicates either  Loss of lead in power to that section (check circuit breakers and / or isolators) Loss of Lead in Data (Check Data connectivity to the lead in cabinet and the data connectivity from the LED processor ...

    • The display has strange blotching / jittering or resolution problems ?

      This would indicate an incorrect firmware on the Novastar receiver card for all OR part of the  Display. The resolution is to retrieve the firmware that is located on the supplied project USB And upload it to the cabinet / s receiver cards that are ...

    • When we look over the front of the screen it is not uniform ?

      When installing display you should stop and evaluate after each row to ensure alignment, there is lots of adjustment to be made by adjusting the 4 affixing bolts to each cabinet AND checking the interconnecting locks between cabinets have in fact ...

    • How to clean outdoor screen

      Hose it off. Low pressure. These are only IP65 front so low-pressure water jets only. A soft brush may be used. Only run horizontally or vertically or they may dislodge led lamps. Do not press hard. Worst case isopropyl alcohol and a soft lint free ...