BDL4052E - When Human Sensor is enabled, screen goes to standby after about 2 minutes
This issue is likely due to the settings on the screen inherited from the Factory testing.
Please perform Deep Factory reset by following the SOP below to resolve the issue
The SOP above will wipe out the screen's app and configuration
Office use only:
#18873
Related Articles
Philips BDL Remote Control Not Working
Philips Signage Remote control not working: [1] Are you using the correct remote control (RC)? Part number: 398GRABDDNEPHT, see picture below: See important note at the end of this document [2] The green led must blink when you press the OK button on ...BDL - Android Base Screen - Logging
The log file from an android based BDL models can be downloaded via the remote control or via ADB. 1. Via the remote control: Insert an USB stick in the monitor, press “home 1666 back” in a sequence on the remote control > the log file will be copied ...BDL4550D - Screen not responding to Remote Control
Symptoms Screen can turn on but it doesn't respond to the remote control. Main Reasons The following are possible reasons: 1. Wrong remote control is used 2. Remote is set to the wrong mode 3. Remote IR is not emitting light 4. Remote is not being ...BDL4550D Wifi disabled whenever the screen is put on standby
This is a known bug and is solved with firmware FB01.07 To check the current Firmware version running on the screen, press Info-77 If the Screen SW is below FB01.07, please update it by following the instruction in this article ...BDL Android versions
What are the android versions on BDL? xxBDL3050Q Android 5.0.1 xxBDL3052T Android 5.0.1 xxBDL4050D Android 4.4.4 65BDL3051T Android 4.4.4 xxBDL4051T Android 4.4.4 xxBDL4150D Android 7.1 xxBDL3550Q Android 8.0.0 xxBDL4550D Android 8.0.0 Can I upgrade ...