FSMPv2 - Hard Reset The Device

FSMPv2 - Hard Reset The Device


Resetting the FSMP will erase wifi configuration and Fusion signage identity.
You need to reconfigure the wifi and then you'll get a new Fusion signage identity.
Because of this, you'll also need to:
- delete the old Fusion signage identity from your Fusion portal
- add the new identity to your portal
- assign/schedule new playlist content to the newly added identity


Make sure:
- You are using the FSMP Remote
  
- the remote has a working battery
- point the remote to the FSMP device (NOT THE SCREEN)


Press the Reset Button using a pin



Navigate down to "Wipe data/factory reset"
Press the remote "Power" Button to confirm


Navigate down to "Factory data reset"
Press the remote "Power" Button to confirm


Video of procedure below





    • Related Articles

    • FSMP - Reset the device

      Resetting the FSMP will erase wifi configuration and Fusion signage identity. You need to reconfigure the wifi and then you'll get a new Fusion signage identity. Because of this, you'll also need to: - delete the old Fusion signage identity from your ...

    • FSMPv2 - Reset The Device

      Resetting the FSMP will erase wifi configuration and Fusion signage identity. You need to reconfigure the wifi and then you'll get a new Fusion signage identity. Because of this, you'll also need to: - delete the old Fusion signage identity from your ...

    • FSMPv2 - Device appears offline

      Press the OK button to bring up the Fusion Signage menu If you see the word "offline" that means the Fusion Signage is not connected to the internet. Check that you can access the internet from the device by: - Pressing the Home button - Navigate to ...

    • FSMPv2 - Clear Device Storage

      Using the remote control Press home to bring the android menu Go to the Menu button (6 square at the bottom middle of the android interface) -> settings (cog)->Device preferences->App->Fusion Signage->Clear Storage This will generate a new id of your ...

    • FSMPv2 - When device is set to portrait in the device rotation, it always revert back to landscape after reboot (when using a non-fusion app)

      This is a known issue which is fixed with FSMPv2 20221202 or later Latest SW and update procedure can be found in this article https://support.westan.com.au/portal/en-gb/kb/articles/fsmpv2-updating-the-sw Office Use Only: #9928