Philips Signage Remote control not working: [1] Are you using the correct remote control (RC)? Part number: 398GRABDDNEPHT, see picture below: See important note at the end of this document [2] The green led must blink when you press the OK button on ...
Turn Off touch To turn off touch, you need to send SICP Over IP command to the screen Command SICP Command (HEX) Turn Touch Off 06 01 00 1E 00 18 Turn Touch On 06 01 00 1E 01 19 Turn On Touch To turn on touch, you can send SICP Over IP command above ...
Overview BDL4052E running SW FB0109T.Wave version has 3 mode of determining which USB-B port is active 1. Side I/O USB-B-3 (on the side of the screen, facing the Left when viewed from the front) is always active when the screen source is set to any ...
Overview The screen has 2x USB-B interface. However, only 1 of them can be used at any given time to relay interaction. The active USB-B port can be chosen from within the screen's android menu Setup Press the home button on the remote or the cog on ...
The log file from an android based BDL models can be downloaded via the remote control or via ADB. 1. Via the remote control: Insert an USB stick in the monitor, press “home 1666 back” in a sequence on the remote control > the log file will be copied ...